Cat 2 No-Weld Lower Link Hooks – Set of 2 – SPH430530

Upgrade a compatible tractor three-point hitch with this Cat 2 no-weld lower link hook set. The set contains 2 lower link hooks and mounts to the lift arms with a bolt/clamp connection, so welding is not required.

The system is intended for compatible Cat 2 lift arms measuring up to 95 mm wide and 35–45 mm high. It can be used on the left and right side and is rated for tractors up to 75 kW / 100 PS.

• Cat 2 no-weld lower link hook kit
• Set of 2 hooks
• Bolt/clamp mounting without welding
• For compatible lift arms up to 95 mm wide and 35–45 mm high
• Suitable for left- and right-hand installation
• For tractors up to 75 kW / 100 PS

Cat 2 lower link hooks without welding

Unlike weld-on lower link hooks, this no-weld set is attached mechanically to the existing lift arms. The Easy Change bolt/clamp system is a practical option when a removable installation is preferred or when welding the lift arms is not desired.

Compatibility depends on the three-point category and the dimensions of the tractor lift arms. Measure the mounting area before ordering rather than selecting the set on category or tractor power alone.

What is included?

• 2 × Cat 2 no-weld lower link hook assemblies
• Stabilizer / connecting component
• Spacer, support and mounting components
• Washers and fastening hardware

The supplied mounting components are shown in the product images.

Technical specifications

Lower link hooks

• Category: Cat 2
• Mounting: bolt/clamp mounting, no welding
• Maximum lift-arm width: 95 mm
• Lift-arm height: 35–45 mm
• Pin diameter: 28.5 mm
• Housing: 110 × 45 mm
• Required straight section at lift-arm end: 50 mm (5 cm)
• Maximum tractor power: 75 kW / 100 PS
• Installation side: suitable for left and right
• Hook material: 40CR steel
• Clamp bolt specification: M16 × 120, grade 10.9

Confirm that your tractor uses Cat 2 lower links and measure the lift-arm mounting area. The lift arm must be no more than 95 mm wide and its height must be within 35–45 mm. Also check the 28.5 mm pin diameter, 110 × 45 mm housing dimensions and that at least 50 mm (5 cm) of straight lift arm is available at the end for mounting. The tractor must not exceed the stated 75 kW / 100 PS rating. Cat 2 alone does not guarantee a correct fit.

Installation

The hooks are secured to the lift arms with the bolt/clamp connection. This Easy Change mounting system does not require welding. Position and secure the components correctly and check that the linkage can move freely before use. Recheck the fastening after installation and during regular maintenance. At least 50 mm (5 cm) of straight lift arm is required at the end for installation.

Frequently asked questions